Juniper SYSTEM BASICS - CONFIGURATION GUIDE V 11.1.X Configuration Manual page 499

priority burst
priority over-subscription-factor
priority rate
protocol burst
Use the no version to remove the attachment of the DoS protection group from
the interface.
See pppoe dos-protection-group.
Use to set the burst size in packets for the priority.
Example
host1(config-dos-protection)#priority Hi-Green-IC burst 32
Use the no version to return to the default value.
See priority burst.
Use to set the oversubscription value for the priority rate limiter.
The oversubscription value and the priority rate are used to calculate the
minimum rate limits for port compression.
Allows an oversubscription of the priority rate because all protocols within a
priority are not generally used simultaneously.
Example
host1(config-dos-protection)#priority Hi-Green-IC over-subscription-factor 100
Use the no version to return no oversubscription value.
See priority over-subscription-factor.
Use to set the rate in packets-per-second for the priority.
Example
host1(config-dos-protection)#priority Hi-Green-IC rate 6000
Use the no version to return to the default value of 0.
See priority rate.
Use to set the burst size in packets-per-second for the protocol.
The default value is one half the maximum rate in packets.
Example
host1(config-dos-protection)#protocol IpLocalDhcpIc burst 65535
Use the no version to set the default value, which is equal to half of the configured
maximum rate.
See protocol burst.
Chapter 7: Passwords and Security
Denial of Service (DoS) Protection
469