Upgrading To Nsm 2010.4 Release On An Nsm Central Manager Appliance (Online Mode) - Juniper NETWORK AND SECURITY MANAGER 2010.4 - INSTALLATION GUIDE REV1 Installation Manual

Table of Contents

Advertisement

Network and Security Manager Installation Guide

Upgrading to NSM 2010.4 Release on an NSM Central Manager Appliance (Online mode)

158
This section describes upgrading to NSM 2010.4 on an NSM Central Manager appliance
if the appliance is connected to the Internet.
NOTE: NSM 2010.4 for Central Manager does not require a license file.
Use the following procedure to upgrade to NSM 2010.4 on an NSM CM appliance.
From the NSM Software Download page, click the Central Manager upgrade link to
1.
download the NSM Central Manager Appliance software. The downloaded file has
the name
nsm2010.4_servers_upgrade_cm.zip
Copy this file onto your NSM CM appliance using FTP or SCP.
2.
Log in as the admin user, and answer n when prompted to run the setup wizard.
3.
Enter sudo su - and enter the admin password to gain root access.
4.
Confirm that the
5.
unzip
following command:
which unzip
This command gives you the location of the
following command to install this utility:
yum install unzip
Navigate to the directory where you saved the downloaded file, which is typically the
6.
/tmp/
subdirectory.
Enter the following command to unzip and save the two files
7.
(
nsm2010.4_servers_cm.sh
Central Manager system:
unzip nsm2010.4_servers_upgrade_cm.zip
Enter the following command to automatically start the installation.
8.
sh upgrade-os.sh nsm2010.4_servers_cm.sh
The installer begins a series of preinstallation checks that ensures:
You are installing the correct software for your operating system.
All the necessary software binaries are present.
You correctly logged in as root.
You have installed a version of NSM earlier than the current version you are installing.
The system has sufficient disk space and RAM.
.
utility is present on the NSM CM appliance by entering the
unzip
,
) and a directory (
upgrade-os.sh
utility. If it is not available, use the
) on the NSM
apps-rpms
Copyright © 2010, Juniper Networks, Inc.

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the NETWORK AND SECURITY MANAGER 2010.4 - INSTALLATION GUIDE REV1 and is the answer not in the manual?

This manual is also suitable for:

Network and security manager 2010.4

Table of Contents