Juniper SYSTEM BASICS - CONFIGURATION GUIDE V 11.1.X Configuration Manual page 548

JUNOSe 11.1.x System Basics Configuration Guide
show boot
show hardware
518
Displaying Boot Information
Use to show the current boot settings.
Example
host1#show boot
System Release:
System Configuration:
Note: This system is not configured with backup settings.
See show boot.
Use to display detailed information about the system hardware.
Field descriptions
slot Physical slot that contains the module
type Type of module
serial number Serial number of the module
assembly number Part number of the module
assembly rev Hardware revision of the module
ram (MB) Memory capacity of the host processor
number of MAC addresses Total number of Ethernet addresses on an I/O
module
base MAC address Lowest Ethernet address on an I/O module
Example
host1#show hardware
slot type
---- ----------------
0 SRP-10Ge
1 SRP-10Ge
2 ---
3 ---
4 CT3-12
5 OC3/OC12/DS3-ATM
6 GE/FE
slot type
---- -------------
0 ---
1 SRP-10Ge I/O
2 ---
release.rel
running-configuration
serial assembly
number number
---------- ----------
4305358981 3500005472
4305359020 3500005472
--- ---
--- ---
4305337201 3500010901
4605300290 3500103958
4605340294 3500104554
serial assembly
number number
---------- ----------
--- ---
4605250426 3500003302
--- ---
assembly ram
rev. (MB)
-------- ----
A06 2048
A06 2048
--- ---
--- ---
A07 128
A06 256
A08 256
number
of
assembly MAC
rev. addresses
-------- ---------
--- ---
A02 1
--- ---