Juniper SYSTEM BASICS - CONFIGURATION GUIDE V 11.1.X Configuration Manual page 232

JUNOSe 11.1.x System Basics Configuration Guide
bulkstats interfaces description-format common
bulkstats interface-type
202
Collecting Bulk Statistics
Use the no version to set the system to retrieve bulk statistics periodically, the
default situation.
See bulkstats collector.
Use to set the encoding scheme of the ifDescr object that the bulk statistics
application reports to the conventional industry method.
This command provides compatibility with software that uses the industry
encoding scheme.
For more information, see "Configuring Encoding Method" on page 162.
Example
host1(config)#bulkstats interfaces description-format common
Use the no version to return to the proprietary method of encoding.
See bulkstats interfaces description-format common.
Use to configure the interface or subinterface type on which you want to collect
statistics.
You can provide an interface specifier (location) to identify a specific interface
on which you want to collect statistics.
If you define more than one collector, you must specify a unique collector index,
in the range 1–65535.
The supported interface types are:
atm Collects statistics on ATM interfaces
atm1483 Collects statistics on ATM 1483 interfaces
ethernet Collects statistics on Ethernet interfaces
frame-relay Collects statistics on Frame Relay interfaces
frame-relay-sub Collects statistics on Frame Relay subinterfaces
hdlc Collects statistics on Cisco HDLC interfaces
ip Collects statistics on IP interfaces
mplsMajor Collects statistics on MPLS major interfaces
mplsMinor Collects statistics on MPLS minor interfaces
mplsL2shim Collects statistics on MPLS shim interfaces
ppp Collects statistics on PPP
vlan Collects statistics on VLAN subinterfaces