Monitoring Schema Statistics - Juniper SYSTEM BASICS - CONFIGURATION GUIDE V 11.1.X Configuration Manual

Monitoring Schema Statistics

You are able to display your configuration and monitor the data generated by
schemas.
show bulkstats schema
Use to display data on the bulk statistics schema.
Field descriptions
Schema Information:
Index Index number of the schema
Subtree Type of bulk statistics schema configured on the collector: igmp,
if-stack, if-stats, policy, QoS, or system
CollectorIndex Bulk statistics collector index (same as the SNMP table
index)
State
active Schema is properly configured and currently active
notInService Schema has been decommissioned by a management
client
notReady Schema does not have enough configuration information to
go active
error Configuration/operational error
Subtree List Types of statistics the schema is configured to receive
Example 1 Displays bulk statistics information for a schema that is configured
to retrieve the if-stack and system information.
host1#show bulkstats schema
Schema Information:
Index Subtree
----- -----------------
1 ifStack
2 system
Index Subtree List
----- -------------------------------------------------
1 N/A
2 N/A
Example 2 Displays bulk statistics configuration information for a schema that
is configured to retrieve interface usage information (specified by the ifstats
keyword) for the out-errors, lower-interface, and time-offset counters. The
schema is also configured for retrieving the global system and per-module
statistics information (specified by the system keyword).
Chapter 4: Configuring SNMP
CollectorIndex State
-------------- --------
1 active
2 active
Collecting Bulk Statistics
235