Table of Contents
Advertisement
CHAPTER 3 Media Flow Manager Web-Based Interface
Figure 35
System Config > SNMP Page Detail (SNMP Configuration)
Trap Sinks
View, Remove, Enable, and/or Disable trap sinks; trap sinks are created enabled. An SNMP
"trap" is an unsolicited message issued by a managed device to the management station; a
"trap sink" is where the trap is sent. See
Add New Trap Sink
Add hosts to receive traps. See
•
Trap Sink IP—Add hosts to receive SNMP traps.
•
Community—Specify which community of traps to send to this host; default is "public."
•
Trap Type—Specify the SNMP version of traps to send to this host; choices are v1 or v2c.
Click Add New Trap Sink to complete adding the new trap sink. Click Save at the top of the
page to make changes persistent across reboots.
Figure 36
System Config > SNMP Page Detail (Trap Sinks)
56
System Config
snmp traps events
Figure 36.
Media Flow Manager Administrator's Guide
for more information.
Copyright © 2010, Juniper Networks, Inc.
Advertisement
Table of Contents
