Juniper SYSTEM BASICS - CONFIGURATION GUIDE V 11.1.X Configuration Manual page 286

JUNOSe 11.1.x System Basics Configuration Guide
disable
do
enable
256
Using the CLI
host1(config)#
Example 2
host1#configure
Configuring from terminal or file [terminal]? file
File name: system1.scr
Proceed with configure? [confirm]
host1(config)#
There is no no version.
See configure.
Use to exit Privileged Exec mode and return to User Exec mode.
Use to move to a lower Privileged Exec mode level without returning to User
Exec mode. Specifying a privilege level after the disable command changes the
Privileged Exec mode to the lower level that you specify; you do not return to
User Exec mode.
Example 1
host1#disable
host1>
Example 2
host1#show privilege
Privilege level is 10
host1#disable 5
host1#show privilege
Privilege level is 5
There is no no version.
See disable.
Use to issue an Exec mode command from any CLI configuration command
mode.
Example
host1(config)#do show configuration | begin interface
The do command functions the same as the run command.
There is no no version.
See do.