Juniper SYSTEM BASICS - CONFIGURATION GUIDE V 11.1.X Configuration Manual page 528

JUNOSe 11.1.x System Basics Configuration Guide
ip addr 10.1.<#i#>.1 255.255.255.0
!
<# i++ #>
<# endwhile #>
!
<# endtmpl #>
If you stored this macro remotely in the macro file, pc:/macros.mac, you issue the
following commands to execute the macro:
Alternatively, if you stored this macro locally in the macro file atm0verDs3.mac, you
issue the following commands to execute the macro:
The following example shows a portion of the output resulting from executing the
atm0verDs3 macro from a local file (the starting and ending comments vary for a
remote macro):
host1(config)#!Macro 'atmOverDs3' in the file 'atmOverDs3.mac' starting execution
host1(config)#controller t3 9/1
host1(config)#no shut
host1(config)#clock source internal module
host1(config)#framing cbitadm
host1(config)#ds3-scramble
host1(config)#interface atm 9/1
host1(config)#atm vc-per-vp 256
host1(config)#controller t3 9/2
host1(config)#no shut
host1(config)#clock source internal module
host1(config)#framing cbitadm
host1(config)#ds3-scramble
host1(config)#interface atm 9/2
host1(config)#atm vc-per-vp 256
host1(config)#controller t3 9/3
host1(config)#no shut
host1(config)#clock source internal module
host1(config)#framing cbitadm
host1(config)#ds3-scramble
host1(config)#interface atm 9/3
host1(config)#atm vc-per-vp 256
host1(config)#interface atm 9/1.1
host1(config)#encap pppoe
host1(config)#interface atm 9/1.1.1
host1(config)#encap ppp
host1(config)#no ppp shut
host1(config)#no ppp keep
host1(config)#atm pvc 1 1 1 aal5mux ip
host1(config)#ip addr 10.1.1.1 255.255.255.0
[display omitted]
498
Running Macros
host1>enable
host1#conf t
host1(config)#macro pc:/macros.mac atm0verDs3
host1>enable
host1#conf t
host1(config)#macro verbose atm0verDs3
(Id: 103)