Juniper SYSTEM BASICS - CONFIGURATION GUIDE V 11.1.X Configuration Manual page 66

JUNOSe 11.1.x System Basics Configuration Guide
The only commands that cannot be preceded by run or do are the configure
command and those commands that are already available in all modes, such as sleep
or exit.
Example 1
host1(config)#run show config | begin interface
interface null 0
!
interface fastEthernet 0/0
!
interface gigabitEthernet 5/0
!
interface atm 6/0
interface atm 6/0.1 point-to-point
!
interface atm 6/0.1.7
!
interface atm 6/0.1.5
!
interface atm 6/0.1.2
!
interface atm 6/0.1.9
!
interface atm 6/0.1.11
!
interface atm 6/0.1.15
!
interface atm 6/0.1.18
!
ip route 0.0.0.0 0.0.0.0 10.6.128.1
ip route 10.10.121.72 255.255.255.255 10.6.128.1
!
!
route-map adsf permit 10
router dvmrp
!
router igmp
!
snmp-server community private view everything rw
snmp-server contact Mary
snmp-server
!
! End of generated configuration script.
host 1(config)#int fa 0/0
Example 2
host1(config-if)#do dir
Please wait...
------------------
reboot.hty
system.log
soft_clear_in.mac
erx_3-3-1.rel
erx_3-3-1.rel
autocfg.scr
Capacity = 224133120, Bytes Free = 44986177, Reserved = 36700160
host1(config-if)#
36
Overview
ip address 10.6.129.41 255.255.128.0
encapsulation pppoe
file size
--------
31040
20481
8578
71082105
70502991
unshared
size date (UTC)
-------- -------------------
31040 10/30/2001 15:31:10
20481 10/26/2001 17:24:16
8578 10/24/2001 14:39:02
71082105 10/25/2001 13:02:50
70502991 10/24/2001 19:58:08
355 355 09/28/2001 13:33:04
in
use
---
!