Copying The Image On The Primary Srp Module - Juniper SYSTEM BASICS - CONFIGURATION GUIDE V 11.1.X Configuration Manual

JUNOSe 11.1.x System Basics Configuration Guide

Copying the Image on the Primary SRP Module

NOTE: The information in this section does not apply to the ERX310 router, which
does not support SRP module redundancy.
You can copy the contents of NVS on the primary SRP module to a spare flash card.
To do so:
1.
2.
3.
flash-disk duplicate
NOTE: This command is available only in Boot mode.
388
Managing Flash Cards on SRP Modules
host1#no mount disk1
% Device is dismounted
host1#flash-disk initialize disk1
WARNING: Execution of this command will cause the contents of disk1 to be
erased.
Proceed with Flash disk initialization? [confirm]
Please wait..............................
There is no no version.
See flash-disk initialize.
Access Boot mode.
a. From Privileged Exec mode, enter the reload command. Information about
the reloading process is displayed.
b. When the countdown begins, press the mb key sequence (case-insensitive).
This CLI enters Boot mode (:boot## prompt).
If you do not press the mb key sequence, the reloading process continues
and returns the CLI to the normal User Exec mode.
Issue the flash-disk duplicate command.
Follow the instructions on the screen. When prompted, insert the original or
spare flash card in the primary SRP module.
Use to copy the contents of the primary flash card to a spare flash card.
The primary and spare flash cards must be from the same manufacturer and
must have the same size.
When you issue the flash-disk duplicate command, insert the original and spare
flash cards when prompted. The router copies the flash card contents
incrementally, so you may need to exchange the flash cards several times.
Example
host1#halt primary-srp
host1#reload