Juniper SYSTEM BASICS - CONFIGURATION GUIDE V 11.1.X Configuration Manual page 252

JUNOSe 11.1.x System Basics Configuration Guide
bulkstats schema subtree igmp
bulkstats schema subtree policy
222
Collecting Bulk Statistics
Example 2 Configures the schema to retrieve final statistics that may have been
lost during a higher create or delete frequency, for the specified interface
host1(config)#bulkstats schema 5 subtree if-stats if-create-delete-time-stats
interfaceType ?
atm1483 Configure bulkstats for ATM 1483 sub-interfaces
ip Configure bulkstats for IP interfaces
mplsL2Shim Configure bulkstats for MPLS shim Interfaces
mplsMajor Configure bulkstats for MPLS major Interfaces
mplsMinor Configure bulkstats for MPLS minor Interfaces
ppp Configure bulkstats for PPP interfaces
vlan Configure bulkstats for VLAN Sub-Interfaces
Use the no version to delete the specified schema.
See bulkstats schema subtree.
Use to collect IGMP usage data.
To collect IGMP statistics for one or more IGMP attributes, use the subtreelist
keyword.
To retrieve the offset from the master interval at which the record was created
for the bulk statistics interface record, use the time-offset keyword.
Example Configures the schema to collect the destination address and
time-offset attributes for IGMP.
host1(config)#bulkstats schema 4 subtree igmp dest-address time-offset
Use the no version to delete the specified schema.
See bulkstats schema subtree.
Use to collect statistics about a specified policy or a policy type, or based on
color-coded tags applied by a policy.
To collect statistics for a specified policy, use the policy-name keyword.
To collect data on input policies, local input policies, output policies, or secondary
output policies, use the policy-type keyword.
To collect statistics based on color-coded tags applied by a policy, use the
policy-subtreelist keyword.
You create policies using the policy-list command. For information, see the
JUNOSe Policy Management Configuration Guide
Example Configures the schema to collect statistics for a policy named
XMYpolicy
host1(config)#bulkstats schema 4 subtree policy policy-name XMYpolicy