Juniper SYSTEM BASICS - CONFIGURATION GUIDE V 11.1.X Configuration Manual page 373

System basics configuration guide software for e series broadband services routers
Table of Contents

Advertisement

show fabric weights
show hosts
below -5C is too cold
above 79C is too hot
low temperature warning below 10C
high temperature warning above 51C
IOA temperature ranges
below -5C is too cold
above 79C is too hot
low temperature warning below 10C
high temperature warning above 56C
See show environment.
Use to display multicast-to-unicast ratio for the router switch fabric.
Field descriptions
multicast Ratio value of multicast bandwidth
unicast Ratio value of unicast bandwidth
Example
host1#show fabric weights
Fabric scheduler weights: multicast = 1 , unicast = 8
See show fabric weights.
Use to display a list of configured network servers.
Field descriptions
Static Host Table Information about the connected static hosts
name Name of the host
ip address IPv4 or IPv6 address of the host
type of host Type of host; for example, ftp means an FTP server
NFS Host Table Information about connected NFS servers
name Name of the NFS server
userid Identity for the user
groupid Identity for the group
Example
host1#show hosts
Static Host Table
-----------------
name
ip address
----
-----------
host1
10.2.0.124
hFtp
10.5.6.7
Chapter 5: Managing the System
type
----
ftp
ftp
Monitoring the System
343

Advertisement

Table of Contents
loading

This manual is also suitable for:

Junose 11.1

Table of Contents