Juniper SYSTEM BASICS - CONFIGURATION GUIDE V 11.1.X Configuration Manual page 574

JUNOSe 11.1.x System Basics Configuration Guide
aaa domain-map
ip vrf
telnet listen
virtual-router
544
Configuring Virtual Routers
VRF : southern
host1#
Map a VR to a user domain name in Domain Map Configuration mode. The VR
must already exist.
host1(config)#aaa domain-map jacksonville
host1(config-domain-map)#virtual-router western
host1(config-domain-map)#
Use to map a user domain name to a virtual router.
Examples
host1-0-1-90(config)#aaa domain-map juniper.net vrouter_1
host1-0-1-90(config)#aaa domain-map none vrouter__all_purpose
host1-0-1-90(config)#aaa domain-map DEFAULT vrouter_all_purpose
Use the no version to delete the domain map.
See aaa domain-map.
Use to create a VRF or access VRF Configuration mode to configure a VRF.
You must specify a route distinguisher after you create a VRF. Otherwise, the
VRF will not operate.
Example
host1-00-02-80:boston(config)#ip vrf vpn-A
Use the no version to remove a VRF.
See ip vrf.
Use to create a Telnet daemon to listen in a virtual router.
Example
host1(config)#virtual-router 3
host1:3(config)#telnet listen port 3223
Use the no version to delete the daemon.
See telnet listen.