Juniper SYSTEM BASICS - CONFIGURATION GUIDE V 11.1.X Configuration Manual page 275

show snmp trap
Global Entry Limit Value : 500
No notification log name information is available
See show snmp notificationLog.
Use to display configuration information about SNMP traps and trap destinations.
Field descriptions
Enabled Categories Trap categories that are enabled on the router.
SNMP authentication failure trap Enabled or disabled.
Trap Source Interface whose IP address is used as the source address for
all SNMP traps.
Trap Source Address IP address used as the source address for all SNMP
traps.
Trap Proxy Enabled or disabled.
Global Trap Severity Level Global severity level filter; if a trap does not
meet this severity level, it is discarded. If the per-category trap severity level
is not set for a particular category, the severity displayed here is used for
that category.
Trap Severity Level Severity level filter for a trap category; this severity
level overrides the globally configured trap severity level.
TrapCategories Types of traps enabled on the router for which trap severity
is configured at the category level.
Address IP address of the trap recipient.
Security String Name of the SNMP community.
Ver SNMP version (v1 or v2) of the SNMP trap packet.
Port UDP port on which the trap recipient accepts traps.
Trap Categories Types of traps that the trap recipient can receive.
TrapSeverityFilter Severity level filter for this SNMP host.
Ping TimeOut Configured ping timeout in minutes.
Maximum QueueSize Maximum number of traps to be kept in the trap
queue.
Queue DrainRate Maximum number of traps per second to be sent to the
host.
Queue Full discard method Method used to discard traps when the queue
is full:
dropFirstIn Oldest trap in the queue is dropped.
Chapter 4: Configuring SNMP
245
Monitoring SNMP