Table of Contents
Advertisement
Configuring vty Lines
By default five vty lines (0–4) are open. You can open additional lines using the line
vty command. Once lines are open, login is enabled by default. Before users can
access the lines, you must configure a password, disable login using the no login
command, or configure AAA authentication on the lines.
line vty
password
Use to open or configure vty lines.
You can specify a single line or a range of lines. The range is 0–29.
Example
host1(config)#line vty 6 10
host1(config-line)#
Use the no version to remove a vty line or a range of lines from the configuration.
Lines that you remove will no longer be available for use by Telnet, FTP, or SSH.
When you remove a vty line, the system removes all lines above that line. For
example, no line vty 6 causes the system to remove lines 6 through 29. You
cannot remove lines 0 through 4.
See line.
Use to specify a password on a single line or a range of lines.
If you enable login but do not configure a password, the system will not allow
you to access virtual terminals.
Specify a password in plain text (unencrypted) or cipher text (encrypted). In
either case, the system stores the password as encrypted.
You can use the following keywords:
0 (zero) Specifies an unencrypted password
5 Specifies a secret
7 Specifies an encrypted password
Example 1 (unencrypted password)
host1(config-line)#password 0 mypassword
Example 2 (secret)
host1(config-line)#password 5 y13_x
Example 3 (encrypted password)
host1(config-line)#password 7 x13_2
Chapter 5: Managing the System
259
Managing vty Lines
Advertisement
Table of Contents
Troubleshooting
