Juniper SYSTEM BASICS - CONFIGURATION GUIDE V 11.1.X Configuration Manual page 107

Table 10: Command Mode Overview (continued)
Mode Name Use of Mode
Layer 2 Control Neighbor
Configuration
LDP Configuration
Line Configuration
Local IPSec Transport
Profile Configuration
Local User Configuration
Access to Mode
Configure ANCP (L2C)
neighbor parameters.
host1(config-l2c-
neighbor)#
Configure MPLS LDP
profile parameters.
host1(config-ldp)#
Modify a virtual
terminal line.
host1(config-line)#
Configure preshared
IKE keys for L2TP over
IPSec profiles.
host1(config-ipsec-transport-
profile-local)#
Configure user
parameters in local
user databases.
host1(config-local-user)#
Chapter 2: Command-Line Interface
Exit from Mode
From Layer 2
Configuration mode,
use the neighbor
command.
Prompt:
From Global
Configuration mode,
specify the mpls ldp
profile command.
Prompt:
From Global
Configuration mode,
use the line command.
Prompt:
From the IPSec
Transport Profile
Configuration mode,
use the local ip
address command.
Prompt:
From Global
Configuration mode,
specify the aaa local
username or the aaa
local database
command.
Prompt:
Accessing Command Modes
Use the exit command twice to
return to Global Configuration
mode.
Press Ctrl+z to return to Exec
mode.
Use the exit command once to
return to Global Configuration
mode.
Press Ctrl+z to return to Exec
mode.
Use the exit command once to
return to Global Configuration
mode.
Press Ctrl+z to return to Exec
mode.
Use the exit command twice to
return to Global Configuration
mode.
Press Ctrl+z to return to Exec
mode.
Use the exit command to
return to Global Configuration
mode.
Press Ctrl+z to return to Exec
mode.
77