Copying Partial Releases - Juniper SYSTEM BASICS - CONFIGURATION GUIDE V 11.1.X Configuration Manual

Copying Partial Releases

You can shorten the time it takes to copy a release from a server and reduce the
amount of storage needed for a release. At the default setting, all subsystems are
included when you copy a release from a server. Use the exclude-subsystem
command to specify subsystems that you do not want to copy from the server. Use
line number Number of the line to which the user is connected
line name Name of the line, the service the line offers, and the relative line
number
user Name of the user
connected from Location or IP address of the user
connected since Date and time that the user connected to the line
idle time Amount of time it has been since an entry was made from this
line (detail only)
virtual router Virtual router used by this line user (detail only)
privilege level Privilege level of this line user (detail only)
current command Command currently being executed by the user over
this line (detail only)
Example 1
host1#show users
line
number line name
------ --------------
0* console 0
4 vty 3 (ftp)
5 vty 4 (telnet)
Note: '*' indicates current user.
Example 2
host1#show users detail
line
number line name
------ --------------
0 console 0
1* vty 0 (telnet)
line virtual privilege
number router
------ ------- ---------
0 default 10
1* default 10
Note: '*' indicates current user.
See show users.
connected
user from
----- ----------
console
fred 10.10.0.64
10.10.0.64
connected
user from
---- ------------
console
10.10.120.90
level current command
-----------------
show users detail
Chapter 5: Managing the System
connected since
----------------
02/12/2001 19:57
02/12/2001 20:04
02/12/2001 20:04
idle
connected since time
---------------- --------
08/14/2003 08:01 00:23:50
08/15/2003 10:37
313
Transferring Files