Juniper SYSTEM BASICS - CONFIGURATION GUIDE V 11.1.X Configuration Manual page 114

JUNOSe 11.1.x System Basics Configuration Guide
Table 10: Command Mode Overview (continued)
Mode Name Use of Mode
Subscriber Policy
Configuration
Traffic Class
Configuration
Traffic Class Group
Configuration
Tunnel Group
Configuration
Tunnel Group Tunnel
Configuration
84
Accessing Command Modes
Access to Mode
Configure a nondefault
subscriber policy for a
subscriber (client)
bridge group interface.
host1(config-policy)#
Configure a traffic
class.
host1(config-traffic-class)#
Configure a traffic class
group.
host1(config-traffic-class-
group)
Add up to 31 tunnel
definitions to a tunnel
group.
host1(config-tunnel-group)#
Configure attributes for
a tunnel group tunnel.
host1(config-tunnel-group-
tunnel)#
Exit from Mode
From Global
Configuration mode,
use the
subscriber-policy
command and specify
the alphanumeric name
of the subscriber policy.
Prompt:
From Global
Configuration mode,
use the traffic-class
command.
Prompt:
From Global
Configuration mode,
use the
traffic-class-group
command.
Prompt:
From Global
Configuration mode,
use the aaa
tunnel-group
command and specify
the name of the tunnel.
Prompt:
From Tunnel Group
Configuration mode,
use the tunnel
command and specify
the tag value (1-31) of
the tunnel.
Prompt:
Use the exit command once to
return to Global Configuration
mode.
Press Ctrl+z to return to Exec
mode.
Use the exit command once to
return to Global Configuration
mode.
Press Ctrl+z to return to Exec
mode.
Use the exit command once to
return to Global Configuration
mode.
Press Ctrl+z to return to Exec
mode.
Use the exit command once to
return to Global Configuration
mode.
Press Ctrl+z to return to Exec
mode.
Use the exit command twice to
return to Global Configuration
Mode.
Press Ctrl+z to return to Exec
mode.