(Question Mark Key); Table 6: Help Commands - Juniper SYSTEM BASICS - CONFIGURATION GUIDE V 11.1.X Configuration Manual

JUNOSe 11.1.x System Basics Configuration Guide
or the lack of a space before the ? gives different results. Table 6 on page 64 describes
the help system.

Table 6: Help Commands

Commands listed in the left column of Table 6 on page 64 are further described with
examples in the following sections.

? (Question Mark Key)

You can use the question mark (?) key whenever you need additional information.
When you enter ?, all available choices are displayed. The CLI then redisplays the
command you typed. The following examples show different ways you can use the
? key.
When you use ? on a line by itself or when it is preceded by one or more spaces, a
list of all next available choices is displayed.
Example 1
host1(config)#?
64
Using Help
Command Description
? Lists all keywords applicable to the current command mode
help Displays a brief description of the help system
(available in all command modes)
partial-keyword? Lists the keywords that begin with a certain character string
partial-keyword<Tab> Completes the partial keyword you entered, if you have provided an
unambiguous abbreviation
command<Space>? Lists the set of all valid next available choices
aaa
access-list
arp
bandwidth
banner
baseline
boot
bulkstats
classifier-list
clns
clock
confirmations
controller
crypto
default
disable-autosync
disable-switch-on-error
do
enable
end
Configure authentication, authorization, and
accounting characteristics
Configure an access list entry
Configure a static ARP entry
Configure slot-group bandwidth control
Define a banner line
Configure baseline operations
Configure boot time behavior
Configure bulkstats parameters
Configure a classifier list entry
Configure CLNS characteristics
Set the system's clock
Configure confirmation mode
Configure controller parameters
Configure cryptographic parameters
Set a command to its default(s)
Disable automatic synchronization of redundant
system controller file system
Disable automatic switch to redundant system
controller upon software/hardware error
Run an exec mode command (alias command run)
Configure security related options
Exit Global Configuration mode