Juniper SYSTEM BASICS - CONFIGURATION GUIDE V 11.1.X Configuration Manual page 236

JUNOSe 11.1.x System Basics Configuration Guide
206
Collecting Bulk Statistics
notReady Collector does not have enough configuration information
to go active
error Configuration or operational error
Index Bulk statistics collector index number
Primary-Receiver Index number of the primary receiver to which the
system transfers data, if defined
Second-Receiver Index of the secondary receiver to which the system
transfers data
Last Transfer Failure Last time that the collector attempted to retrieve
statistics and was unsuccessful
Interval Start Time Start of current interval of bulk collections. The
collector began collecting bulk statistics at this time.
Interval Stop Time End of current interval of bulk collections.
Schema Information:
Index Index number of the schema
Subtree Type of bulk statistics schema configured on the collector:
if-stack, if-stats, policy, QoS, or system
CollectorIndex Bulk statistics collector index number
Create-Delete Time Stats State of final statistics collection (enabled or
disabled)
Create-Delete Interface Type Interface type associated with final
statistics collection (ATM 1483, IP, PPP)
State
active Schema is properly configured and currently active
notInSvc Schema has been decommissioned by a management
client
notReady Schema does not have enough configuration information
to go active
error Configuration or operational error
Subtree List Types of statistics the schema is configured to receive
Interface Types:
Index Index number of the interface type entry
Type Interface type for which bulk statistics collection is configured