Juniper SYSTEM BASICS - CONFIGURATION GUIDE V 11.1.X Configuration Manual page 110

JUNOSe 11.1.x System Basics Configuration Guide
Table 10: Command Mode Overview (continued)
Mode Name Use of Mode
QoS Interface Superet
Configuration
QoS Parameter
Definition Configuration
QoS Profile
Configuration
QoS Shared Shaper
Control Configuration
Queue Profile
Configuration
80
Accessing Command Modes
Access to Mode
Configure QoS
interface supersets.
host1(config-qos-
interface-superet)#
Configure QoS
parameter definitions.
host1(config-qos-
parameter-define)#
Configure QoS profiles.
host1(config-qos-profile)#
Configure variables
within the simple
shared shaper
algorithm.
host1(config-qos-shar
ed-shaper-control)#
Configure queue
profiles.
host1(config-queue)#
Exit from Mode
From Global
Configuration mode,
use the
qos-interface-superset
command.
Prompt:
From Global
Configuration mode,
use the
qos-parameter-define
command.
Prompt:
From Global
Configuration mode,
use the qos-profile
command.
Prompt:
From Global
Configuration mode,
use the
qos-shared-shaper-control
command.
Prompt:
From Global
Configuration mode,
use the queue-profile
command.
Prompt:
Use the exit command once to
return to Global Configuration
mode.
Press Ctrl+z to return to Exec
mode.
Use the exit command once to
return to Global Configuration
mode.
Press Ctrl+z to return to Exec
mode.
Use the exit command once to
return to Global Configuration
mode.
Press Ctrl+z to return to Exec
mode.
Use the exit command once to
return to Global Configuration
mode.
Press Ctrl+z to return to Exec
mode.
Use the exit command once to
return to Global Configuration
mode.
Press Ctrl+z to return to Exec
mode.