Password Protection - Juniper SYSTEM BASICS - CONFIGURATION GUIDE V 11.1.X Configuration Manual

Set operating parameters.
Gain access to Global Configuration mode.

Password Protection

If the system administrator has configured the system to have a password, the CLI
prompts you to enter that password before you receive access to Privileged Exec
mode. The password is case sensitive and appears as asterisks on the screen.
To access Privileged Exec mode:
At the prompt, type enable and press Enter.
1.
host1>enable
Password:
At the password prompt, type your password and press Enter.
2.
Password:*********
host1#
NOTE: The > character in the command-line prompt changes to the # character.
host1# ?
baseline
clear
clock
configure
copy
debug
default
delete
dir
disable
disconnect
enable
exit
flash-disk
halt
help
ip
ipv6
l2tp
log
logout
macro
more
mpls
mtrace
to
no
ping
pppoe
profile-reassign
Set a baseline for statistics
Clear a state
Set the system's clock
Enter Global Configuration mode
Copy files
Configure debugging functions
Set a command to its default(s)
Delete a local file
Display a list of local files
Reduce the command privilege level
Disconnect remote CLI session
Enable access to privileged commands
Exit from the current command mode
Perform flash disk operations
Halt the system in preparation for power down
Describe the interactive help system
Configure IP attributes on an interface
Configure IPv6 attributes
L2TP operations
Configure logging settings
Logout PPP Subscribers
Run a CLI macro
Display contents of a file
Execute MPLS commands
Trace the path that packets will traverse from source
destination for a given group
Negate a command or set its default(s)
Send echo request to remote host
Set PPPoE information
Perform profile reassignment
Accessing Command Modes
Chapter 2: Command-Line Interface
87