Juniper SYSTEM BASICS - CONFIGURATION GUIDE V 11.1.X Configuration Manual page 497

ethernet dos-protection-group
frame-relay dos-protection-group
hdlc dos-protection-group
ip dos-protection-group
Use to create a DoS protection group and enter DoS Protection Group
Configuration mode.
A group named default always exists.
Example
host1(coonfig)#dos-protection-group default
Use the no version to remove the DoS protection group.
See dos-protection-group.
Use to attach an Ethernet DoS protection group to an interface.
Example
host1(config-if)#ethernet dos-protection-group group1
Use the no version to remove the attachment of the DoS protection group from
the interface.
See ethernet dos-protection-group.
Use to attach a Frame Relay DoS protection group to an interface.
Example
host1(config-if)#frame-relay dos-protection-group group1
Use the no version to remove the attachment of the DoS protection group from
the interface.
See frame-relay dos-protection-group.
Use to attach an HDLC DoS protection group to an interface.
Example
host1(config-if)#hdlc dos-protection-group group1
Use the no version to remove the attachment of the DoS protection group from
the interface.
See hdlc dos-protection-group.
Use to attach an IP DoS protection group to an interface.
Example 1
host1(config-if)#ip dos-protection-group group1
Chapter 7: Passwords and Security
Denial of Service (DoS) Protection
467