Juniper SYSTEM BASICS - CONFIGURATION GUIDE V 11.1.X Configuration Manual page 567

Timezone Offset Time difference between the time zone and UTC, in
hours:minutes
Access List Identities of access lists of servers from which the system
does not accept broadcasts
'Server Source' Interface Interface through which responses from the
NTP server are directed; configured through the ntp server source
command, which overrides the interface configured through the ntp
source command.
'Client Source' Interface Interface through which all NTP server
responses are directed; configured through the ntp source command.
Source Interface IP address of the interface to which NTP servers should
send NTP responses
Address IP address of interface
Enable Status of NTP on the interface, On or Off
BcastClient Indication of whether or not this interface accepts
broadcasts from NTP servers, On or Off
BcastServer Indication of whether or not this interface functions as a
broadcast server, On or Off
Name Type of interface and its location
Example
host1# show ntp status
Network Time Protocol (NTP v.4)
NTP Status
No. of associations
Clock Status
Offset Error
Frequency Error
Last Update
Root Dispersion
Configuration:
Admin. State
Virtual Router Name
Broadcast Delay
Client Mode
Master Mode
Stratum No.
Summer Time
Summer Timezone Name
Timezone Name
Timezone Offset
Access List
'Server Source' Interface
'Client Source' Interface
Interface Configuration
Chapter 10: Configuring the System Clock
:No valid NTP server available
: 0
:Initializing: frequency to be calibrated
: 0 sec, amortizing asymptotically
: 0 sec/sec, compensating every second
:
: 0 sec
: NTP Enabled
: default
: 3000 microseconds
: True
: False
: Unspecified
: False
:
: UTC
: 00:0 hours:minutes
:
:
: Default (transmit interface)
:
Monitoring NTP
537