Juniper SYSTEM BASICS - CONFIGURATION GUIDE V 11.1.X Configuration Manual page 104

JUNOSe 11.1.x System Basics Configuration Guide
Table 10: Command Mode Overview (continued)
Mode Name Use of Mode
IP Service Profile
Configuration
IPSec CA Identity
Configuration
IPSec Identity
Configuration
IPSec IKE Policy
Configuration
IPSec Manual Key
Configuration
74
Accessing Command Modes
Access to Mode
Create a service profile
to use in route maps
for subscriber
management and to
authenticate
subscribers with
RADIUS.
host1(config-service-
profile)#
Create an IPSec
identity used in online
certificate requests and
during negotiations
with IKE peers.
host1(config-ca-identity)#
Create an IPSec
identity used in offline
certificate requests and
during negotiations
with IKE peers.
host1(config-ipsec-
identity)#
Define an IKE policy.
host1(config-ike-policy)#
Enter manual keys.
host1(config-manual-key)#
Exit from Mode
From Global
Configuration mode,
use the ip
service-profile
command and specify
a service profile name
with up to 32 ASCII
characters.
Prompt:
From the Global
Configuration mode,
use the ipsec ca
identity command.
Prompt:
From the Global
Configuration mode,
use the ipsec identity
command.
Prompt:
From the Global
Configuration mode,
use the ipsec
ike-policy-rule
command.
Prompt:
From Global
Configuration mode,
use the ipsec key
manual pre-share
command.
Prompt:
Use the exit command once to
return to Global Configuration
mode.
Press Ctrl+z to return to Exec
mode.
Use the exit command once to
return to Global Configuration
mode.
Press Ctrl+z to return to Exec
mode.
Use the exit command once to
return to Global Configuration
mode.
Press Ctrl+z to return to Exec
mode.
Use the exit command once to
return to Global Configuration
mode.
Press Ctrl+z to return to Exec
mode.
Use the exit command once to
return to Global Configuration
mode.
Press Ctrl+z to return to Exec
mode.