Juniper SYSTEM BASICS - CONFIGURATION GUIDE V 11.1.X Configuration Manual page 400

JUNOSe 11.1.x System Basics Configuration Guide
adapter erase
slot accept
370
Replacing IOAs on the E120 Router and the E320 Router
Example Accepting the IOA in the upper bay of slot 5 in an E320 router
host1(config)#adapter accept 5/0
There is no no version.
See adapter accept.
Use to delete the configuration of the specified IOA in the specified IOA bay
before you install a different type of IOA.
This command enables you to create a fresh configuration for the IOA to be
installed in the IOA bay.
Issuing this command reboots the line module associated with the IOA, but it
does not erase the line module's configuration. To erase the configuration of the
line module and its associated IOAs, issue "slot erase" on page 371 command.
Issuing this command erases the interfaces associated with the specified IOA.
To erase the interfaces for both IOAs installed in a slot, issue the slot erase
command.
Example Erasing the IOA in the upper bay of slot 5 in an E320 router
host1(config)#adapter erase 5/0
There is no no version.
See adapter erase.
Use to delete the configuration of the module in the selected slot after you install
a different type of module.
This command enables you to create a fresh configuration for the module installed
in the slot.
You can also use this command to accept an empty slot that was previously
occupied.
You cannot use this command on a primary SRP module; however, you can use
it on a standby SRP module.
You can use this command only when the state of the module in the slot is not
present or disabled (mismatch).
If you specify a slot on an E120 or E320 router that contains an SRP module,
you accept the configuration of the SC subsystem on that slot by default. You
do not, however, accept the configuration of the fabric slice that resides on the
slot.
Use the srp keyword to accept only the configuration of the portion of the
SC subsystem that resides on a specified SRP module.
Use the fabric keyword to accept only the configuration of the fabric slice
that resides on the specified SRP module.