Table of Contents
Advertisement
host1(config)#ipsec identity
host1(config-ipsec-identity)#?
IPSec IKE Policy Configuration Mode
In this mode, you can create an IKE policy, which is used during IKE phase 1
negotiation.
From the Global Configuration mode, type ipsec ike-policy-rule and the policyNumber,
and press Enter.
host1(config)#ipsec ike-policy-rule 10
host1(config-ike-policy)#?
IPSec Manual Key Configuration Mode
In this mode, you can enter the manual key that a peer uses for authentication during
the tunnel establishment phase.
From the Global Configuration mode, type ipsec key manual pre-share and the
peerIPaddress, and press Enter.
host1(config)#ipsec key manual pre-share 10.10.1.1
host1(config-manual-key)#?
common-name
Common Name
country
Country name
default
Set a command to its default(s)
do
Run an exec mode command (alias command run)
domain-name
Domain name
exit
Exit from the current command mode
help
Describe the interactive help system
log
Configure logging settings
macro
Run a CLI macro
no
Negate a command or set its default(s)
organization
Organization name
sleep
Make the Command Interface pause for a specified duration
aggressive-mode
Allows aggressive mode negotiation for the tunnel
authentication
Configure the authentication method
default
Set a command to its default(s)
do
Run an exec mode command (alias command run)
encryption
Configure the encryption algorithm within an IKE policy
exit
Exit from the current command mode
group
Configure the Diffie-Hellman group identifier
hash
Configure the hash algorithm within an IKE policy
help
Describe the interactive help system
lifetime
Configure the time an SA will live before expiration
log
Configure logging settings
macro
Run a CLI macro
no
Negate a command or set its default(s)
run
Run an exec mode command (alias command do)
sleep
Make the Command Interface pause for a specified duration
default
Set a command to its default(s)
do
Run an exec mode command (alias command run)
exit
Exit from the current command mode
help
Describe the interactive help system
key
Manually specify a key
log
Configure logging settings
macro
Run a CLI macro
Chapter 2: Command-Line Interface
Accessing Command Modes
99
Advertisement
Table of Contents
Troubleshooting
