Task 5: Copy The Release Files To The Network Host; Task 6: Configure Access To The Network Host - Juniper SYSTEM BASICS - CONFIGURATION GUIDE V 11.1.X Configuration Manual

4.
5.

Task 5: Copy the Release Files to the Network Host

If you downloaded the software from the Juniper Networks website as a .zip file,
uncompress the files to a directory, and copy the release files to the network host.
If you are accessing the release files from one of the software CDs that you created
from the image bundle in compressed format that you downloaded from the Juniper
Networks website, you must mount the CD. The way you mount the release files on
the network host depends on the type of computer you use, the operating system,
and the network configuration. To find out how to mount the release files on the
network host, review the manual for the operating system, or contact your network
administrator.

Task 6: Configure Access to the Network Host

To configure access to the network host:
1.
2.
3.
Configure an IP address on the interface.
On ERX7xx models, ERX14xx models, and the ERX310 router:
host1#configure
Configuring from terminal or file [terminal]?
Enter configuration commands, one per line. End with CNTL/Z.
host1(config)#interface fastEthernet 6/0
host1(config-if)#ip address ipAddress [ mask ]
On the E120 and E320 routers:
host1#configure
Configuring from terminal or file [terminal]?
Enter configuration commands, one per line. End with CNTL/Z.
host1(config)#interface fastEthernet 6/0/0
host1(config-if)#ip address ipAddress [ mask ]
Press Ctrl+z to return to Privileged Exec mode.
Use the ping command to determine whether the router can reach the network
host.
host1#ping hostname
If the router can reach the network host, go to the next section. Otherwise, go
to Step 2.
Determine whether a route exists between the router and the network host.
host1#show ip route
If the appropriate route is displayed, go to Step 5. Otherwise, proceed with Step 3.
Configure a route to reach the network host.
host1#configure
Configuring from terminal or file [terminal]?
Chapter 3: Installing JUNOSe Software
Installing Software When a Firewall Exists
129