Table 10: Command Mode Overview - Juniper SYSTEM BASICS - CONFIGURATION GUIDE V 11.1.X Configuration Manual

JUNOSe 11.1.x System Basics Configuration Guide

Table 10: Command Mode Overview

Mode Name Use of Mode
AAA Profile
Configuration
Address Family
Configuration
ATM VC Class
Configuration
ATM VC Configuration
70
Accessing Command Modes
Access to Mode
Configure new AAA
profiles.
host1(config-aaa-profile)#
Configure BGP or RIP
address family
parameters.
host1(config-router-af)#
Configure a class of
attributes for an ATM
data PVC.
host1(config-vc-class)#
Configure individual
attributes for an ATM
data PVC.
host1(config-subif-atm-vc)#
Exit from Mode
From Global
Configuration mode,
use aaa-profile
command.
Prompt:
From Global
Configuration mode,
use router bgp or
router rip to enter
Router Configuration
mode. From Router
Configuration, use the
address-family
command.
Prompt:
From Global
Configuration mode,
use the vc-class atm
command, and specify
the name of the VC
class.
Prompt:
From Global
Configuration mode,
use the interface
command to enter
Subinterface
Configuration mode.
From Subinterface
Configuration mode,
use the pvc command.
Prompt:
Use the exit command to
return to Global Configuration
mode.
Press Ctrl+z to return to Exec
mode.
Use the exit command twice to
return to Global Configuration
mode.
Press Ctrl+z to return to Exec
mode.
Use the exit command to
return to Global Configuration
mode.
Press Ctrl+z to return to Exec
mode.
Use the exit command twice to
return to Global Configuration
mode.
Press Ctrl+z to return to Exec
mode.