Juniper SYSTEM BASICS - CONFIGURATION GUIDE V 11.1.X Configuration Manual page 115

Table 10: Command Mode Overview (continued)
Mode Name Use of Mode
Tunnel Profile
Configuration
Tunnel Server
Configuration
User Exec
VRF Configuration
VR Group Configuration
Access to Mode
Configure tunnel
profile parameters.
host1(config-tunnelprofile)#
Configure the
maximum number of
tunnel-service
interfaces for a
dynamic tunnel-server
port.
host1(config-tunnel-server)#
Change terminal
settings on a
temporary basis.
Show system
host1>
information.
Access Privileged Exec
mode.
Configure VRF
parameters for
BGP/MPLS VPNs.
host1(config-vrf)#
Configure a virtual
router group for AAA
broadcast accounting.
host1(config-vr-group)#
Chapter 2: Command-Line Interface
Exit from Mode
From Global
Configuration mode,
specify the mpls
tunnels profile
command.
Prompt:
From Global
Configuration mode,
use the tunnel-server
command and identify
the slot/port location of
the dynamic
tunnel-server port.
Prompt:
Log into system.
Prompt:
From Global
Configuration mode,
use the ip vrf
command.
Prompt:
From Global
Configuration mode,
use aaa accounting
vr-group to enter VR
Group Configuration
mode.
Prompt:
Accessing Command Modes
Use the exit command once to
return to Global Configuration
mode.
Press Ctrl+z to return to Exec
mode.
Use the exit command once to
return to Global Configuration
mode.
Press Ctrl+z to return to Exec
mode.
Use the enable command to
enter Privileged Exec mode.
Use the exit command to log
out of the CLI.
Use the exit command once to
return to Global Configuration
mode.
Press Ctrl+z to return to Exec
mode.
Use the exit command twice to
return to Global Configuration
mode.
Press Ctrl+z to return to Exec
mode.
85