Juniper SYSTEM BASICS - CONFIGURATION GUIDE V 11.1.X Configuration Manual page 109

Table 10: Command Mode Overview (continued)
Mode Name Use of Mode
Policy Parameter
Configuration
PPPoE Service Name
Table Configuration
Privileged Exec
Profile Configuration
QoS Interface Set
Configuration
Access to Mode
Configure a policy
parameter.
host1(config-policy-parameter)#
Configure services for
a PPPoE service name
table.
host1(config-pppoe-service-
name-table)#
Show system
information.
Set operating
parameters.
Access Global
host1#
Configuration mode.
Configure profiles.
host1(config-profile)#
Configure QoS
interface sets.
host1(config-qos-
interface-set)#
Chapter 2: Command-Line Interface
Exit from Mode
From Global
Configuration mode,
use the
policy-parameter
command.
Prompt:
From Global
Configuration mode,
use the
pppoe-service-name-table
command, and specify
the alphanumeric name
of the PPPoE service
name table.
Prompt:
From User Exec mode,
use the enable
command.
Prompt:
From Global
Configuration mode,
use the profile
command.
Prompt:
From Global
Configuration mode,
use the
qos-interface-set
command.
Prompt:
Accessing Command Modes
Use the exit command once to
return to Global Configuration
mode.
Press Ctrl+z to return to Exec
mode.
Use the exit command once to
return to Global Configuration
mode.
Press Ctrl+z to return to Exec
mode.
Use the disable command to
return to User Exec mode.
Use the exit command to log
out of the CLI.
Use the configure command to
enter Global Configuration
mode.
Use the exit command once to
return to Global Configuration
mode.
Press Ctrl+z to return to Exec
mode.
Use the exit command once to
return to Global Configuration
mode.
Press Ctrl+z to return to Exec
mode.
79