Juniper SYSTEM BASICS - CONFIGURATION GUIDE V 11.1.X Configuration Manual page 276

System basics configuration guide software for e series broadband services routers
Table of Contents

Advertisement

JUNOSe 11.1.x System Basics Configuration Guide
show snmp trap statistics
246
Monitoring SNMP
dropLastIn Most recent trap is dropped .
Example
host1# show snmp trap
Enabled Categories: Bgp, Ospf, Sonet
SNMP authentication failure trap is disabled
Trap Source: FastEthernet 6/0, Trap Source Address:172.27.120.78
Trap Proxy: enabled
Global Trap Severity Level: 7 - debug
Trap Severity Level
-------------------
7 - debug
Address
Security String
---------------
-------------------
192.168.1.10
public
Address
TrapSeverityFilter
------------ ------------------ ------- --------- --------- -------------
192.168.1.10
2 - critical
See show snmp trap.
Use to display statistics for all SNMP traps on the virtual router, as well as statistics
for each SNMP host configured on the virtual router.
Field descriptions
Trap request(s) Number of local traps requested
Proxy trap request(s) Number of proxy traps requested
Trap(s) discarded Total number of traps discarded
No system memory Traps discarded because there was not enough
system memory
No queue resources Traps discarded because there were no queue
resources available
SNMP agent disabled Traps discarded because the SNMP agent was
disabled
Global trap category disabled Traps discarded because they were filtered
by the snmp enable trap command
Global minimum severity level Traps discarded because they did not
match the severity level set with the snmp enable traps trapfilters
command.
Trap(s) out Total number of traps sent by the virtual router
TrapCategories
-------------------
ospf
Ver
Port
---
-----
v1
162
Ping
Maximum
TimeOut QueueSize DrainRate discrd methd
1
32
Trap Categories
----------------
BgpOspf
Queue
Queue Full
0
dropLastIn

Advertisement

Table of Contents
loading

This manual is also suitable for:

Junose 11.1

Table of Contents