Juniper SYSTEM BASICS - CONFIGURATION GUIDE V 11.1.X Configuration Manual page 68

JUNOSe 11.1.x System Basics Configuration Guide
!
interface ip s10
!
interface atm 2/0
!
no atm aal5 snmp trap link-status
no atm aal5 shutdown
!
interface atm 2/0.1 point-to-point
!
ip route 0.0.0.0 0.0.0.0 10.13.5.1
ip debounce-time 0
ip source-route
!
router ospf 5
! Area 0.0.0.0
!
! Trap Source: <not configured>
! Note: SNMP server not running.
!
host1#
In the following example, the output display consists only of lines that contain the
Example 2
string ip. The system omits all other lines of the output from the display because
none of them contains the string ip.
host1#show config include-defaults | include ip
! Configuration script generated on WED JUN 06 2001 02:17:00 UTC
Please wait...log verbosity low ipEngine
log verbosity low ipEngineering
log verbosity low ipGeneral
log verbosity low ipInterface
log verbosity low ipNhopTrackerEngineering
log verbosity low ipNhopTrackerGeneral
log verbosity low ipProfileMgr
log verbosity low ipProfileMgrEngineering
!
38
Overview
arp timeout 21600
arp timeout 21600
no shutdown
atm sonet stm-1
loopback line
atm uni-version 3.0
atm oam loopback-location 0xFFFFFFFF
atm vc-per-vp 32768
atm vp-tunnel 1 10
load-interval 300
no atm snmp trap link-status
no atm shutdown
no shutdown
no atm atm1483 shutdown
no atm atm1483 snmp trap link-status
no ospf shutdown
ip route-type both
timers spf 3
maximum-paths 4
ospf auto-cost reference-bandwidth 100
distance ospf intra-area 110
distance ospf inter-area 112
distance ospf external 114
strip-domain disable