Local Ipsec Transport Profile Configuration; Local User Configuration Mode - Juniper SYSTEM BASICS - CONFIGURATION GUIDE V 11.1.X Configuration Manual

JUNOSe 11.1.x System Basics Configuration Guide
NOTE: The privilege command is available in Line Configuration mode when the
user is logged in at privilege level 15. For more information, see "Privileged-Level
Access" on page 49 and "CLI Command Privileges" on page 52 .

Local IPSec Transport Profile Configuration

In this mode, you can configure preshared IKE keys for IPSec transport profiles.
From the IPSec Transport Profile Configuration mode, type local ip address and the
ipAddress, and press Enter.
host1(config-ipsec-transport-profile)#local ip address 10.10.1.1
host1(config-ipsec-transport-profile-local)#?

Local User Configuration Mode

In this mode, you can configure parameters for user entries in local user databases.
From the Global Configuration mode, type either aaa local username and the
userName and databaseName or aaa local database and the databaseName. Then
press Enter.
host1(config)#aaa local username curt38 database westLocal12
host1(config-local-user)#?
106
Accessing Command Modes
default Set a command to its default(s)
do Run an exec mode command (alias command run)
exit Exit from the current command mode
help Describe the interactive help system
log Configure logging settings
macro Run a CLI macro
no Negate a command or set its default(s)
pre-share Specify pre-shared group key based on local ip address
pre-share-masked A pre-encrypted key, generated by show config rather than
interactive
run Run an exec mode command (alias command do)
sleep Make the Command Interface pause for a specified duration
default
do
exit
help
ip-address
ip-address-pool
log
macro
no
operational-virtual-router
password
run
secret
sleep
support
Set a command to its default(s)
Run an exec mode command (alias command run)
Exit from the current command mode
Describe the interactive help system
Specify an IP address for the user
Specify an IP address pool for the user
Configure logging settings
Run a CLI macro
Negate a command or set its default(s)
Specify an operational virtual router for the
user
Configure the password
Run an exec mode command (alias command do)
Configure the secret
Make the Command Interface pause for a specified
duration
Enter Support mode