Juniper SYSTEM BASICS - CONFIGURATION GUIDE V 11.1.X Configuration Manual page 450

JUNOSe 11.1.x System Basics Configuration Guide
enable secret
service password-encryption
420
Setting Basic Password Parameters
Use to set a password, which controls access to Privileged Exec mode and some
configuration modes.
Enter the password in plain text (unencrypted) or cipher text (encrypted). In
either case, the system stores the password as encrypted.
The first time you define a password, you must enter it in plain text. To view its
encrypted form, use the show config display. To redefine the password at a later
date, you can enter the password in its encrypted form.
You can use the following keywords:
0 (zero) Specifies an unencrypted password
7 Specifies an encrypted password
Example 1 (unencrypted password)
host1(config)#enable password 0 mypassword
Example 2 (encrypted password)
host1(config)#enable password 7 x13_2
Use the no version to remove the password.
See enable password.
Use to set a secret, which controls access to the Privileged Exec mode and some
configuration modes.
Enter the secret in plain text (its unencrypted form) or cipher text (its encrypted
form). In either case, the system stores the secret as encrypted.
The first time you define a secret, you must enter it in plain text. To view its
encrypted form, use the show config display. To redefine the secret at a later
date, you can enter the secret in its encrypted form.
You can use the following keywords:
0 (zero) Specifies an unencrypted secret
5 Specifies an encrypted secret
Example 1 (unencrypted secret)
host1(config)#enable secret 0 yalta45
Example 2 (encrypted secret)
host1(config)#enable secret 5 y13_x
Use the no version to remove the secret.
See enable secret.