Enabling Warm Restart Diagnostics; Table 44: Supported Line Modules - Juniper SYSTEM BASICS - CONFIGURATION GUIDE V 11.1.X Configuration Manual

Table 44: Supported Line Modules

The number of diagnostic tests that the system performs on line modules depends
on whether you have configured line module redundancy. If you enable warm restart
diagnostics on the spare line module when all other line modules are active, the
system performs diagnostic tests on the spare line module including the spare I/O
module.
Enabling warm restart diagnostics on a primary line module forces the line module
to switch over to the spare line module.
To ensure complete diagnostic test coverage, we recommend that you disable line
module redundancy using the redundancy lockout command before enabling warm
restart diagnostics.

Enabling Warm Restart Diagnostics

Use the diag command to enable warm restart diagnostics on a module.
diag
Line Module
cOCx FO
CT3/T3-F0
OCx/STMx ATM
GE/FE
GE-2
GE-HDE
OC3/STM1 GE/FE
OC48
ES2 4G LM
ES2 10G Uplink LM
Use to restart the specified SRP module or line module and enable the system
to perform diagnostic tests on the module.
Use the force keyword to enable the system to manually confirm conflicting
conditions when the slot of the active SRP module is specified.
If you specify a slot on the E120 and E320 routers that contains an SRP module,
you can use the subsystem variable to perform diagnostic tests on a subsystem
on the SRP module. We recommend that you perform diagnostic tests on one
subsystem at a time to avoid interrupting network traffic transmitting through
the fabric modules.
Chapter 6: Managing Modules
Enabling Warm Restart Diagnostics on Modules
405