Upgrading From Release 5.1.1 Or Lower-Numbered Releases; Table 15: Release Compatibility - Juniper SYSTEM BASICS - CONFIGURATION GUIDE V 11.1.X Configuration Manual

System basics configuration guide software for e series broadband services routers
Table of Contents

Advertisement

JUNOSe 11.1.x System Basics Configuration Guide
6.
7.
8.
9.

Upgrading from Release 5.1.1 or Lower-Numbered Releases

Release 5.1.1 or lower-numbered releases only support application images up to 172
MB. To install larger application images for Release 6.0.0 and higher-numbered
releases, you must first install Release 5.1.2 (or the highest-numbered 5.x.x release).
This enables the system to support application images greater than 172 MB. For
example, you cannot go from Release 5.1.1 to Release 7.2.0 without first upgrading
to Release 5.1.2. See Table 15 on page 142.

Table 15: Release Compatibility

Your software upgrades may be available remotely through Telnet or FTP, or may
be delivered on a new NVS card. Depending on how you access the software updates,
there are two different procedures to follow. See the appropriate section for
instructions:
142
Upgrading from Release 5.1.1 or Lower-Numbered Releases
Wait for the redundant SRP module to boot, initialize, and reach the standby
state. When the module is in standby state, the REDUNDANT LED is on and the
ONLINE LED is off. The State field in the show version display indicates the
module is in standby.
After any type of reboot, the primary and redundant SRP module NVS file systems
are unsynchronized again.
Synchronize the NVS file system of the redundant module with that of the primary
module.
host1#synchronize
Switch from the primary SRP module to the redundant SRP module.
host1#srp switch
The redundant SRP module becomes the primary. The former primary SRP
module reboots and becomes the redundant.
Reenable autosynchronization.
host1(config)#no disable-autosync
Highest Release Able
JUNOSe Release
to Load
5.1.1 or lower-numbered
5.3.5p0-2 or the
release
highest-numbered
5.x.x release
5.1.2 or higher-numbered
No limitation
release
7.2.0 or higher-numbered
No limitation
release
Maximum
Cannot Load
Application Image
6.x.x or
~172 MB
higher-numbered
release
Not applicable
~234 MB
Not applicable
~256 MB

Advertisement

Table of Contents
loading

This manual is also suitable for:

Junose 11.1

Table of Contents