Juniper SYSTEM BASICS - CONFIGURATION GUIDE V 11.1.X Configuration Manual page 112

JUNOSe 11.1.x System Basics Configuration Guide
Table 10: Command Mode Overview (continued)
Mode Name Use of Mode
Route Map Configuration
Router Configuration
RSVP Configuration
RTR Configuration
Scheduler Profile
Configuration
82
Accessing Command Modes
Access to Mode
Configure routing
tables and source and
destination
information.
host1(config-route-map)#
Configure a routing
protocol.
host1(config-router)#
Configure an RSVP
profile.
host1(config-rsvp)#
Configure RTR
parameters.
host1(config-rtr)#
Configure shaping
parameters.
Configure scheduler
profiles.
host1(config-scheduler-
profile)#
Exit from Mode
From Global
Configuration mode,
use the route-map
command.
Prompt:
From Global
Configuration mode,
specify a routing
protocol with the router
command.
Prompt:
From Global
Configuration mode,
use the mpls rsvp
profile command.
Prompt:
From Global
Configuration mode,
use the rtr command.
Prompt:
From Global
Configuration mode,
use the
scheduler-profile
command.
Prompt:
Use the exit command once to
return to Global Configuration
mode.
Press Ctrl+z to return to Exec
mode.
Use the exit command once to
return to Global Configuration
mode.
Press Ctrl+z to return to Exec
mode.
Use the exit command once to
return to Global Configuration
mode.
Press Ctrl+z to return to Exec
mode.
Use the exit command once to
return to Global Configuration
mode.
Press Ctrl+z to return to Exec
mode.
Use the exit command once to
return to Global Configuration
mode.
Press Ctrl+z to return to Exec
menu.