Juniper SYSTEM BASICS - CONFIGURATION GUIDE V 11.1.X Configuration Manual page 106

JUNOSe 11.1.x System Basics Configuration Guide
Table 10: Command Mode Overview (continued)
Mode Name Use of Mode
L2 Transport
Load-Balancing-Circuit
Configuration
L2TP Destination Profile
Configuration
L2TP Destination Profile
Host Configuration
L2TP Tunnel Switch
Profile Configuration
Layer 2 Control
Configuration
76
Accessing Command Modes
Access to Mode
Configure Martini layer
2 transport circuit
associated with
load-balancing group.
host1(config-l2transp
ort-load-balancing-ci
rcuit)#
Define the location of
an LAC.
host1(config-l2tp-dest-
profile)#
Configure host profile
attributes.
host1(config-l2tp-dest-
profile-host)#
Configure the L2TP
tunnel switching
behavior for interfaces
to which this profile is
assigned.
host1(config-l2tp-tun
nel-switch-profile)#
Configure ANCP (L2C)
parameters.
host1(config-l2c)#
Exit from Mode
From Global
Configuration mode,
specify the mpls
l2transport
load-balancing-group
command.
Prompt:
From Global
Configuration mode,
use the l2tp
destination profile
command.
Prompt:
From L2TP Destination
Profile Configuration
mode, use theremote
host command.
Prompt:
From Global
Configuration mode,
use the l2tp
switch-profile
command, and specify
the name of the L2TP
tunnel switch profile.
Prompt:
From Global
Configuration mode,
use the l2c command.
Prompt:
Use the exit command once to
return to Global Configuration
mode.
Press Ctrl+z to return to Exec
mode.
Use the exit command once to
return to Global Configuration
mode.
Press Ctrl+z to return to Exec
mode.
Use the exit command twice to
return to Global Configuration
mode.
Press Ctrl+z to return to Exec
mode.
Use the exit command once to
return to Global Configuration
mode.
Press Ctrl+z to return to Exec
mode.
Use the exit command once to
return to Global Configuration
mode.
Press Ctrl+z to return to Exec
mode.