Juniper SYSTEM BASICS - CONFIGURATION GUIDE V 11.1.X Configuration Manual page 377

show reboot-history
--------- ------- ----------- --------
_unassoc_ (40M)
default (339K)
test (366K)
vr5 (327K)
--------- ------- ----------- --------
Total: 41M
Example 3
host1#show processes memory virtual-router vr5 application ip
*** Memory usage summary (by VRF) ***
application: ip
router: vr5
current
vrf size utilization headroom
--- ------- ----------- --------
vr5 (19K) 48%
See show processes memory.
Use to display the history of system and module resets.
You can display the current reboot.hty file or a saved reboot history file.
If you have a redundant router, it can be convenient to copy the redundant
module's reboot.hty file to another filename for viewing with this command.
Field descriptions
Entry Number of entry in the reboot history; numbers range from lowest
(most recent reset) to highest (oldest reset)
time of reset Timestamp for reset
run state State of system at reset
image type Type of image running when the record is written
boot Module is running the boot file
diagnostics Module is running the diagnostics file
application Module is running the software file
location Slot that reset; location is offset by two slots at slot 7 and above
(the SRP module in slot 6 shows location as slot 7, the SRP module in slot 7
shows location as slot 9, and slots 8-13 show location as 10-15, respectively).
build date Build date of software version
reset type Cause of reset
Example
Chapter 5: Managing the System
7% 99%
23% 100%
23% 100%
18% 100%
7% 99%
100%
Monitoring the System
347