Table of Contents
Advertisement
JUNOSe 11.1.x System Basics Configuration Guide
From Tunnel Group Configuration mode, type tunnel and the tag number (in the
range 1–31) for the tunnel, and press Enter.
host1(config-tunnel-group)#tunnel 1
host1(config-tunnel-group-tunnel)#?
Tunnel Profile Configuration Mode
In this mode, you can create and configure MPLS tunnel profiles.
From Global Configuration mode, type mpls tunnels profile and the profileName,
and press Enter.
host1(config)#mpls tunnels profile storm
host1(config-tunnelprofile)#?
Tunnel Server Configuration Mode
In this mode, you can configure (provision) the maximum number of tunnel-service
interfaces to be used on a dynamic tunnel-server port.
From Global Configuration mode, type tunnel-server and the slot number and port
number of the dynamic tunnel-server port, and press Enter.
host1(config)#tunnel-server 2/2
host1(config-tunnel-server)#?
122
Accessing Command Modes
address
Configure tunnel endpoint address
client-name
Configure the client hostname of the tunnel
default
Set a command to its default(s)
do
Run an exec mode command (alias command run)
exit
Exit from the current command mode
help
Describe the interactive help system
identification
Configure tunnel identification
log
Configure logging settings
macro
Run a CLI macro
max-sessions
Configure maximum sessions for this tunnel
medium
Configure tunnel medium
no
Negate a command or set its default(s)
password
Configure tunnel password
preference
Configure tunnel preference
receive-window
Configure the receive window size for this tunnel
router-name
Configure the virtual-router for the domain name
run
Run an exec mode command (alias command do)
server-name
Configure the remote hostname for the tunnel
sleep
Make the Command Interface pause for a specified duration
source-address
Configure tunnel source address
type
Configure tunnel type
default
Set a command to its default(s)
do
Run an exec mode command (alias command run)
exit
Exit from the current command mode
help
Describe the interactive help system
log
Configure logging settings
macro
Run a CLI macro
no
Negate a command or set its default(s)
run
Run an exec mode command (alias command do)
sleep
Make the Command Interface pause for a specified duration
tunnel
Configure tunnel interface parameters
default
Set a command to its default(s)
Advertisement
Table of Contents
Troubleshooting
Need help?
Do you have a question about the SYSTEM BASICS - CONFIGURATION GUIDE V 11.1.X and is the answer not in the manual?
Questions and answers