Chapter 3
Installing IDS-4215
Align the compact flash device with the connector on the riser card.
Step 2
Press until the compact flash device is fully seated in the connector.
Step 3
Replace the hard-disk drive.
Step 4
For the procedure, see
Step 5
Replace the chassis cover.
For the procedure, see
Removing and Installing the 4FE Card
Only trained and qualified personnel should be allowed to install, replace, or service this equipment.
Warning
Statement 1030
Caution
Follow proper safety procedures when installing and removing the 4FE card by reading the safety
warnings in
4200 Series Appliance
78-16124-01
Compact Flash
memory card
Replacing the Hard-Disk Drive, page
Replacing the Chassis Cover, page
Regulatory Compliance and Safety Information for the Cisco Intrusion Prevention System
Sensor.
Installing Cisco Intrusion Prevention System Appliances and Modules 5.0
Removing and Installing the 4FE Card
3-16.
3-13.
3-19