Table of Contents
Advertisement
Chapter 4
Basic Setup—CiscoWorks 1105/1130/1130-19
Step 3
Step 4
Step 5
Logging into the Web Interface and Verifying
Connectivity
Note
Step 1
78-16345-01
Configure Netscape Navigator to accept all cookies:
a.
Expand Privacy & Security and select Cookies.
Select Enable all cookies.
b.
Click OK.
c.
Change the default font for improved readability:
Expand Appearance and select Fonts.
a.
b.
From the Proportional list, select Sans Serif and a font size.
From the Sans-serif list, select the desired font.
c.
Click OK.
d.
Some fonts do not change after you use this option.
Note
Disable caching:
Expand Advanced and click Cache. If no subcategories are listed,
a.
double-click Advanced to expand the list.
Under "Compare the page in the cache to the page on the network," select
b.
"Every time I view the page."
Disable pop-up blocker software while using the WLSE web interface.
To verify HTTP and HTTPS connectivity, connect to the WLSE using a
supported, properly configured Web browser and perform the following steps:
To verify HTTP connectivity, enter the system IP address, followed by :1741 (the
default port number).
Installation and Configuration Guide for the CiscoWorks Wireless LAN Solution Engine
Logging into the Web Interface and Verifying Connectivity
4-11
Advertisement
Table of Contents
