Installing the Accessories
Installing and Removing the Bezel
Figure 4-3
Figure 4-3
To install and remove the bezel on IDS-4235 and IDS-4250, follow these steps:
To install the bezel, follow these steps:
Step 1
a.
b.
To remove the bezel, press the left side tab and pull.
Step 2
Installing the Power Supply
You can install a second, redundant power supply and power-supply cooling fan (part number
IDS-PWR=) in IDS-4235 and IDS-4250.
Follow proper safety procedures when performing the following steps by reading the safety warnings in
Caution
Regulatory Compliance and Safety Information for the Cisco Intrusion Prevention System 4200 Series
Appliance
Installing Cisco Intrusion Prevention System Appliances and Modules 5.0
4-10
5.0 documentation is not included in the accessories kits for IDS-4235 and IDS-4250.
Note
These systems are no longer being actively manufactured so the newest documentation
is not shipped. You can find 5.0 documentation at this URL:
http://www.cisco.com/en/US/products/hw/vpndevc/ps4077/tsd_products_support_seri
es_home.html
Regulatory Compliance and Safety Information for the Cisco Intrusion Detection and
–
Prevention System 4200 Series Appliance Sensor
shows the Cisco bezel that you can install on IDS-4235 and IDS-4250.
Cisco Bezel
Align the right side tab on the bezel with the slot on the appliance mounting tab.
Press the left side of the bezel into place on the appliance.
Sensor.
Chapter 4
Installing IDS-4235 and IDS-4250
78-16124-01