Network Management (Snmp) Commands - D-Link DXS-3326GSR Reference Manual

The network management commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in
the following table.
The DXS-3326GSR supports the Simple Network Management Protocol (SNMP) versions 1, 2c, and 3. You can specify which
version of the SNMP you want to use to monitor and control the Switch. The three versions of SNMP vary in the level of
security provided between the management station and the network device. The following table lists the security features of the
three SNMP versions:
SNMP Version
v1
v2c
v3
v3
v3
Each command is listed, in detail, in the following sections.
Command
create snmp user
delete snmp user
show snmp user
create snmp view
delete snmp view
show snmp view
create snmp
community
delete snmp
community
show snmp
community
config snmp engineID
DXS-3326GSR Stackable Gigabit Layer 3 Switch
N M
ETWORK
Authentication Method
Community String
Community String
Username
MD5 or SHA
MD5 DES or SHA DES
Parameters
create snmp user <SNMP_name 32> <groupname 32> {encrypted
[by_password auth [md5 <auth_password 8-16> | sha
<auth_password 8-20>] priv [none | des <priv_password 8-16>] |
by_key auth [md5 <auth_key 32-32> | sha <auth_key 40-40>] priv
[none | des <priv_key 32-32>]]}
<SNMP_name 32>
<view_name 32> <oid> view_type [included | excluded]
<view_name 32> [all | oid]
<view_name 32>
<community_string 32> view <view_name 32> [read_only |
read_write]
<community_string 32>
<community_string 32>
<snmp_engineID>
ANAGEMENT
Description
Community String is used for authentication − NoAuthNoPriv
Community String is used for authentication − NoAuthNoPriv
Username is used for authentication − NoAuthNoPriv
Authentication is based on the HMAC-MD5 or HMAC-SHA
algorithms − AuthNoPriv
Authentication is based on the HMAC-MD5 or HMAC-SHA
algorithms − AuthPriv.
DES 56-bit encryption is added based on the CBC-DES
(DES-56) standard
33
(SNMP) C
OMMANDS
7