Network Management (Snmp) Commands - D-Link DGS-3100 SERIES Cli Manual

NETWORK MANAGEMENT (SNMP) COMMANDS

The Network Management commands in the Command Line Interface (CLI) are listed (along with the
appropriate parameters) in the following table.
Command
create snmp user
delete snmp user
show snmp user
create snmp view
delete snmp view
show snmp view
create snmp
community
delete snmp
community
show snmp community
config snmp engineID
show snmp engineID
create snmp group
delete snmp group
show snmp groups
create snmp host
delete snmp host
show snmp host
create trusted_host
show trusted_host
delete trusted_host
enable snmp traps
disable snmp traps
enable snmp
authenticate trap
Parameter
<username 24> <groupname 30> [encrypted [by_password auth [md5
<auth_password 1-32> | sha <auth_password 1-32>] | by_key auth [md5
<auth_key 32 or 64>| sha<auth_key 40 or 72>]]]
<username 24>
<view_name 30> <oid> view_type [included | excluded]
<view_name 30> [all | oid]
{<view_name 30>}
<community_string 20> view <view_name 30> [read_only | read_write]
<community_string 20>
{<community_string 20>}
[default | <snmp_engineID 10-64>]
<groupname 30> [v1 | v2c | v3 [noauth_nopriv | auth_nopriv |
auth_priv]{notify_view <view_name 30>}] {read_view <view_name 30> |
write_view <view_name 30>}
<groupname 30>
<ipaddr> [v1<community_string 20> | v2c<community_string 20> | v3
[noauth_nopriv | auth_nopriv | auth_priv]<auth_string 24>]
<ipaddr>
{<ipaddr>}
<ipaddr>
{<ipaddr>}
<ipaddr>
DGS-3100 Series Gigabit Stackable Managed Switch CLI Manual
6
28