Traffic Segmentation Commands; Config Traffic_Segmentation; Show Traffic_Segmentation - D-Link DGS-1100-16/ME Reference Manual

The Traffic Segmentation commands in the Command Line Interface (CLI) are listed (along with the
appropriate parameters) in the following table.
Command
config
traffic_segmentation
show
traffic_segmentation
Each command is listed in detail, as follows:

config traffic_segmentation

Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To configure ports 1~3 to be able to forward frames to port 5:
DGS-1100-24P/ME:admin#config traffic_segmentation 1-3 forward_list
ports 9
Command : config traffic_segmentation 1-3 forward_list ports 9
Success.
DGS-1100-24P/ME:admin#

show traffic_segmentation

Purpose
DGS-1100/ME Metro Ethernet Managed Switch CLI Reference Guide

TRAFFIC SEGMENTATION COMMANDS

Parameter
<portlist> forward_list [all | ports <portlist>]
{ports <portlist>}
To configure traffic segmentation on the Switch.
config traffic_segmentation <portlist> forward_list [all | ports
<portlist>]
The config traffic_segmentation command configures traffic
segmentation on the Switch.
<portlist> – A port or a port channel for which the current traffic
segmentation configuration on the Switch is to be displayed.
forward_list – Specify a port or a port channel to receive forwarded
frames from the source ports specified in the portlist, above.
all - All ports are specified.
ports <portlist> – Specify a range of ports for the forwarding list.
Only administrator-level users can issue this command.
To display the current traffic segmentation configuration on the
Switch.
126
23