Traffic Segmentation Commands - D-Link DES-3028 Cli Reference Manual

DES-3028 DES-3028P DES-3028G DES-3052 DES-3052P Layer 2 Fast Ethernet Switch CLI Reference Manual
Traffic segmentation allows users to further sub-divide VLANs into smaller groups of ports that will help to reduce traffic on the
VLAN. The VLAN rules take precedence, and then the traffic segmentation rules are applied.
Command
config traffic_segmentation
show traffic_segmentation
Each command is listed, in detail, in the following sections.
config traffic_segmentation
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To configure ports 1 through 10 to be able to forward frames to port 11 through 15:
DES-3028P:4#config traffic_segmentation 1-10 forward_list
11-15
Command:
11-15
Success.
DES-3028P:4#
show traffic_segmentation
Purpose
Syntax
Description
Parameters
T
RAFFIC
Parameters
[<portlist>] forward_list [null | <portlist>]
<portlist>
Used to configure traffic segmentation on the Switch.
config traffic_segmentation [<portlist>] forward_list [null |
<portlist>]
The config traffic_segmentation command is used to configure
traffic segmentation on the Switch.
<portlist>  Specifies a port or range of ports that will be configured
for traffic segmentation.
forward_list  Specifies a range of ports that will receive forwarded
frames from the ports specified in the portlist, above.
 null  No ports are specified
 <portlist>  Specifies a range of ports for the forwarding list.
This list must be on the same Switch previously specified
for traffic segmentation (i.e. following the <portlist>
specified above for config traffic_segmentation).
Only Administrator-level users can issue this command.
config traffic_segmentation
Used to display the current traffic segmentation configuration on the
Switch.
show traffic_segmentation <portlist>
The show traffic_segmentation command is used to display the
current traffic segmentation configuration on the Switch.
<portlist>  Specifies a port or range of ports for which the current
traffic segmentation configuration on the Switch will be displayed.
186
S
EGMENTATION
1-10 forward_list
25
C
OMMANDS