Start A Manual Script - Digi IX20-WAG4 User Manual

Applications
To log script errors to the system log:
n
(config system schedule script 0)> syslog_stderr true
(config system schedule script 0)>
If syslog_stdout and syslog_stderr are not enabled, only the script's exit code is written to the
system log.
8. Set the maximum amount of memory available to be used by the script and its subprocesses:
(config system schedule script 0)> max_memory value
(config system schedule script 0)>
where value uses the syntax number{b|bytes|KB|k|MB|MB|M|GB|G|TB|T}.
9. To run the script only once at the specified time:
(config system schedule script 0)> once true
(config system schedule script 0)>
If once is enabled, rebooting the device will cause the script to run again. The only way to re-
run the script is to:
Remove the script from the device and add it again.
n
Make a change to the script.
n
Disable once.
n
10. Sandbox is enabled by default. This option protects the script from accidentally destroying the
system it is running on.
(config system schedule script 0)> sandbox true
(config system schedule script 0)>
11. Save the configuration and apply the change:
(config)> save
Configuration saved.
>
12. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.

Start a manual script

You can start a script that is enabled and configured to have a run mode of Manual. See

WebUI
1. Log into the IX20 WebUI as a user with Admin access.
2. At the Status page, click Scripts.
The Scripts page displays:
IX20 User Guide
Start a manual script
533