Table of Contents
Advertisement
Containers
New containers are enabled by default. To disable, or to enable a container if it has been
disabled, click Enable.
5. Clone DAL is enabled by default. This allows the container to use the device's system libraries.
6. Enable Virtual Network if the container should have network access:
a. Select a Network Bridge Device that will provide access to the container.
b. (Optional) Enter a static IP Address and netmask for the container. This must be a valid IP
address for the bridge, or, if left blank, a DHCP server can assign the container an IP
address.
c. (Optional) For Gateway, type the IP address of the network gateway.
7. Click to expand Serial ports to sssign serial ports that the container will have access to.
a. For Add Port, click .
b. For Port, select the serial port.
8. Click Apply to save the configuration and apply the change.
Command line
1. Log into the IX20 command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. Create a new container:
(config)> add system container name
(config system container name)>
where name is the
New access points are enabled by default.
4. New containers are enabled by default. To disable:
(config system container name)> enable false
(config system container name)>
IX20 User Guide
Configure a container
676
Advertisement
Table of Contents
